1, must have the corresponding qualifications: according to the provisions of Chinese law, the enterprise contracted to dismantle the oil storage tank project should have: petrochemical dismantling qualification, petrochemical qualification, safety production license, hazardous waste treatment business license, housing construction qualification;
2, according to the national regulations: waste oil tank management national regulations;
3, the technical personnel: the technical person in charge should have more than 5 years of engineering construction technology management experience and intermediate title of engineering sequence, the corresponding technical management personnel and technical construction personnel;
4, with the corresponding engineering construction machinery and equipment and engineering vehicles;
- Process flow of oil storage tank dismantling：
The waste oil storage tank is dismantled and disassembled, and the conventional technical equipment of BJATL technology is used for construction. The oil storage tank is mechanically cleaned and then the cold water cutting process of BJATL is adopted. The construction process is as follows:
1, using the mechanical cleaning equipment of the oil storage tank to clean the inside of the oil storage tank and recover the sludge;
2. Open the manhole for ventilation for a week, and begin to arrange cold cutting equipment when combustible gas and H2S gas content are detected below the safe content;
3, lay mobile cold cut inverted guide rail, hoist in place;
4, the use of ultra high pressure water generator ATL1-75, ATL2-22, ATL2-45, compressed air and abrasive auxiliary, equipped with BJATL normally closed cutting head;
5, the sequence is to disassemble the top of the tank first, then disassemble the coaming, and finally disassemble the bottom of the tank to clean up the site;
6, project acceptance;
1, automatic mechanical cleaning equipment of BJATL is a mature technology equipment, the whole construction process and construction technology is relatively mature, to ensure that the inside of the waste oil storage tank does not contain oil pollution before dismantling;
2, ultra-high pressure water abrasive cutting is also called cold cutting, is the main technical equipment of BJATL technology, can also work normally at the explosion site, the temperature of the cutting part of the whole cutting process does not exceed 60 degrees;
3, the cutting head moves along the track, the movable track can be used repeatedly, the moving of the tool head is driven by servo motor, and the monitoring camera is installed to remotely watch and manage the working state of the tool head in real time;
4, the disassembled steel plate does not contain oil or contains a trace amount of oil, directly recycled to the steel mill;
5, the whole construction process has the advantages of high mechanization, safety, short construction time, low construction cost, is the combination of BJATL Technology's own equipment, equipment technical performance is good;
6, the company provides free technical advice, technical training for users, on-site technical guidance, no worries;
7, provide original parts all year round, can ensure the normal operation of the equipment all year round;
